Bridge troubleshooting in sculpt

[Anonymous]

New to the sculpt enviro. Anyone know how I can troubleshoot/correct this part?

I had a single body that I split off a couple of faces. Now I'm trying to bring the split together in the location shown, but get the warning "Unable to bridge periodic to non-periodic."

When I bridge anyway it seems to break the model.

[Mike.Grau]

 Hi @Anonymous,

Could you perhaps try to use the Create "Face" Feature?

You can select node 4 nodes between two elements and create a new element, like in the picture here.

I hope this helps.

Thanks,

[Anonymous]

Nope, as soon as I select a point the body goes all blocky and doesn't correct itself after the faces are created.

 

[PhilProcarioJr]

Can you upload your model?

[Mike.Grau]

Hi @Anonymous,

Could you may share your model with us?

I would really like to test a couple things.

Thanks,

[Anonymous]

http://a360.co/2ac1EcD

I finished the model last week and was given permission to share it. Took me about a week just looking at the sketch (smalldesCEL.jpg) trying to figure out how I would start.

The part in question was at the front of the eye. I was never able to close it, but it still looks good open.

Attached are a couple of screen shots in gold and silver.