Applying Loads without Constraints

[Anonymous]

Hello,

I am attempting to apply loads to my model in the Simulation environment without constraints. In Solidworks, it is possible to do this via the inertial relief mode, but does Fusion have anything similar? For example, if I am trying to model the forces acting on a rocket flying at an angle of attack, I cannot have the rocket be constrained by a part as that would not realistically model the effects of the stress in a non-constrained environment. Any help would be appreciated!

[tyler_henderson]

Go to the Study Settings>General and turn on "Remove Rigid Body Modes".  This will allow you to solve without Constraints.  You will still get a warning but it will not prevent you from solving.