Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Alignment of Sketches or Bodies to Plane or Point or Axis
Alignment of Sketches or Bodies to Plane or Point or Axis
I'm looking to align imported geometry to a Plane, Axis or Point accurately. Point Data from a CMM or an imported body just seems to be placed in the work envelope with no way to orient it to any meaningful Origin Axis or Plane. I can use the move command but it's not accurate and is quite tedious. Is there a way to say, select 3 points on the flat part of a body and snap move the body (or sketch) to a plane or any such move abilities? Also how about the selection multiple points at once via a window select?
You can create a plane through three points which will then allow you to create a sketch on that plane. Create a joint origin on the sketch and use a joint to position the imported data. Note: This assumes you've imported the data into a separate component.
Fusion
