How does one use a Batch file to Open Fusion 360, Run few dll files in sequence?

[tperam]

How does one use a Batch file to Open Fusion 360, Run few dll files in sequence one after the other created in Visual Studio C++, Then Close Fusion 360.

Can I pass parameters from the batch file into Visual Studio C++?

Regards,
Thurai.

[PinRudolf]

Hi, I'm not sure if this fits your needs:

Use a batch file to start fusion and create a setup-sheet. On the start of fusion you could get some add-ins to run that would read out the setup-sheet and can than call the appropriate dll's?

Using the setup sheet you should be able to pass parameters ass well.

[tperam]

Hi  PinRudolf,

                       Thanks for your response.

I will try your steps and see how it goes.

Thurai