No aplicable
08-25-2016
11:27 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hello everyone. 1st post here. I'm a programmer that's used featurecam for about a year and I'm pretty much learning as I go. Anyway... is there a way to mass edit a solid model? I'm extruding hole patterns and would like to extrude the whole pattern at once vs one at a time. Not sure if this is even possible so I'll ask the experts. Thanks
¡Resuelto! Ir a solución.