I have a scenario where I am milling and overlaying a runway that has 2 concrete slabs that will remain. The alignment is over 8000 ft long. There is an existing profile and finished grade profile. The finished grade "by layout" profile stops and starts when it gets to each of the concrete slabs. The profile itself goes thru the entire alignment, but starts and stops at specific points. Profile and band labeling will only label up to the first concrete slab where the profile stops. It will not label beyond that point, even though the finished grade profile will pick up on the other side of the existing slab to remain and continue.
Profile labels and band labels should label throughout the profile view if the profile exists, not just to the first break point.
Profile_and_Band_Labeling_Feature_Request.mp4
