TOE WALL IN CROSS SECTION

[kbb9327]

DEAR ALL,

I WANT TO SHOW TOE WALL IN CASE-II, WHERE MY RIGHT OF WAY (ROW) IS COMING IN BETWEEN THE EARTHWORK. I WANT TO RESTRICT WITHIN ROW.

IN CASE-I WHERE I HAVE SUFFICIENT ROW, BUT IN CROSS SECTION I WANT TO SHOW BLUE LINE I.E. RIGHT OF WAY IN CROSS SECTION.

I HAVE ATTACHED BOTH PLAN & CROSS SECTION FOR BOTH CASES.

HELP.

[Wojtek_Garczewski]

Hi @kbb9327 

Thanks for posting. As I understood, whenever ROW is encroaching your Earthworks you want to add Retaining Wall subassembly, is this correct?

Have you tried to create an assembly with conditional subassembly?
You can set up polylines targets that whenever case II is present it will find the target polyline and create a retaining wall, otherwise, it will be a daylight.

Please see:

Also, might be helpful:

• To Work With Conditional Assemblies
• Conditional Subassemblies
• Conditional Horizontal Target Subassembly Tips & Tricks - VIDEO 

Please let me know if that helps.

Thanks,
Wojtek

[kbb9327]

Hello

Thank you for reply.

As you can see, i created conditional assembly and i give target to polyline that is ROW, but in cross section what i am looking is not what i wanted.

so what wrong i did?

[Wojtek_Garczewski]

Hi @kbb9327 

Thanks for coming back.

If you want to have an additional slope before your RW, please try to use this configuration:

After Target Found Conditional Subassembly, add Conditional Cut and Fill, then Link Offset and Slope Subassembly with proper slope value and RW subassembly. 

Also, please find the sample file attached for references.

Let me know if it works for you. 

Thanks,

Wojtek
______________________________________________________________

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!

[kbb9327]

Thank you.

Here i am attaching same file with same polyline for whole length.

what i want to say is

Example. if i have stretch of 15 km then

from km 0- km 5 RE wall

Km 5- km 10 Daylight

Km 10-km 15 RE wall

[Wojtek_Garczewski · Accepted solution]

Hi @kbb9327 

In that case, you may have to split polyline into 3 segments, where daylights do not encroach ROW and where it does. Then target polylines in a location where you like to have your Retaining Walls. Otherwise, it will create simple daylight to the surface. Please see:

File for references attached.

Thanks,
Wojtek
______________________________________________________________

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!

[kbb9327]

Thank you @Wojtek_Garczewski for helping.

Got what i want.