Community
Hello everyone,
When I design my subassembly, I add auxilary point by using 0.01:1 slope. It's working but in layout mode it goes infinity. Why does it show like that ?
Hello everyone,
When I design my subassembly, I add auxilary point by using 0.01:1 slope. It's working but in layout mode it goes infinity. Why does it show like that ?
Accepted solution
Hi @gozdeekavas, you might try to change that placing your point not by "slope to surface" but by "DeltaX on Surface". The "DeltaX on Surface" point type gives you the chance of choosing a delta Y for layout view, which means that even though it relies on a surface to be generated, in layout mode, SAC or Civil3D will generate a Link with a length according to your preference.
I hope this helps.
Best regards!
Camilo Fernández
Civil engineer | Specialist in design, construction, and maintenance of roadways
Hi @gozdeekavas, you might try to change that placing your point not by "slope to surface" but by "DeltaX on Surface". The "DeltaX on Surface" point type gives you the chance of choosing a delta Y for layout view, which means that even though it relies on a surface to be generated, in layout mode, SAC or Civil3D will generate a Link with a length according to your preference.
I hope this helps.
Best regards!
Camilo Fernández
Civil engineer | Specialist in design, construction, and maintenance of roadways
Forums Links
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
