Split profile view problem

[alexandru.murariu1989]

Hello!
I have a problem when I want to split the longitudinal profile (have circled the problem profiles). As you can see in the attached dwg on the 3rd sheet I am missing part of the longitudinal profile. Do you have any idea where I am wrong?
Thank you!

[Kyle-L · Accepted solution]

Sometimes Civil 3D is bad at determining the datum level of a split section, such as in your case.

To fix it you will need to change the datum level for the affected section. To do so change the "Split Profile View" to "Manual" and then change the "Adjusted Datum" to a level that ensures your profiles are visible. In this case I chose a level of 326m (see the image below).

[alexandru.murariu1989]

Ty sir!

not to open another topic. how can I set the table to fit on the page. as you can see when I create sheets part of the table head is not in the viewframe