Sample offset profile incorrect

[Anonymous]

Sample offset profile is incorrect. What causes this strange behaviour?

[ilia.borisov]

Sackgasse - DGM - (1) (1) is it existing ground or created by corridor links, if it existing then maybe is incorrect and you would to lower manually surface points in that area, if its corridor surface the assembly (that most probably is custom created by SAC and i cant see it ) has a target that make it bump like that

[Anonymous]

Surface "Sackgasse - DGM - (1) (1)" is existing and shows correctly in plan view and 3D view. Only in profile view it is incorrect

[ilia.borisov]

Then like I said you will need to turn on points of surface and lower them manually.

[Anonymous]

I do not understand. The surface is correct. Why should I lower points of a correct surface? Why the sample offset profile is not correct?

[ilia.borisov]

The sample profile only show you how surface look like at that specific place, the problem is not with the profile but with the surface.

[ilia.borisov]

Ok my mistake I misunderstood you, the problem is that you have wrong surface on profile view, it has to be Surface "Sackgasse - DGM - (1) (1)" but its not.

[ilia.borisov]

Try that Create Profile from surface and add Sackgasse - DGM - (1) (1) and you will see the diference

[Anonymous]

I appreciate your help but you do not understand the problem

[ilia.borisov]

I think You want this result

[Anonymous]

Yes! Including elevation labels in the profile band

[ilia.borisov]

Ok i just change surface in profile view like i said before but you will have to move alignment a little bit because now is on the edge and wont show desired result but the problem is the surface is not on profile view or atleast not that surface that is shown in 3d view

[Anonymous]

Thanks but this is not the solution

[ilia.borisov]

Your alignment just dont lay over that part of the surface that is shown on the 3dview