Need help-conditional subassembly

[Neilw_05]

I need to control my daylight catch point. If the catch point falls within the right of way at 2:1 slope then no change req'd. If the catch point falls outside the right of way @ 2:1 then I want to force it to match EG at the Right of Way. However if that adjusted slope exceeds 1.5 to 1 ratio then it should hold 1.5 to 1 ratio until daylight. I am using a generic slope to surface subassembly.

The distance to the right of way varies.

Suggestions appreciated.

P.S. I am not fluent with Subassembly Composer so Out-Of-The-Box solutions preferred.

[Mike.M.Carlson · Accepted solution]

Hello @Neilw_05 

I think this one should work for your situation:

Autodesk Civil 3D Help: DaylightInsideROW
https://help.autodesk.com/view/CIV3D/2019/ENU/index.html?guid=GUID-728BF864-F5B1-46B6-92A1-A8B0B88F4...

If not, you could build with Subassembly Composer sort of like what Alan shows below:

[Neilw_05]

It looks like one of the solutions will work Mike. I'll mark it solved if it works after I try it tomorrow. Thanks!

[Neilw_05]

Daylight Inside Right of Way subassembly solves it. Thanks again Mike.