Corridor target option missing in 2022.1

[jessica.miller]

Where did this option go in the new target parameter screen??  This option seems to be toggled on by default in the newest version of 2022.1.  We need it toggled off & cannot locate it. 

This is a corridor using an assembly with offset targets.  The targets operated fine prior to an update.  You can see the feature lines here do not find it's target.  There are multiple targets on this side.  

When I uncheck this box the corridor finds it's target just fine.  

The issue is we cannot find this setting in the new parameter UI.  Please advise where this setting can be toggled.  If there is a new option for handling this, please advise.

[cneely]

When  you are in the Target dialog box select an item and it will appear in the lower left. It is greyed out in certain scenarios. 

 

[jessica.miller]

That's right where I'd expect it to be.  Where is it when you have multiple polylines selected as targets?  right now you have none.  

This is what we get

[cneely · Accepted solution]

It's the same place when multiple targets are selected in this example. 

 

[jessica.miller]

thanks.  I'm going to check some other machines.  We may have a bad install.  We've had several folks with this same issue.  Can you send a clip of the version you're in, so I can get it to our IS team?  Maybe it's fixed in an update.

[cneely]

Here's version info. If you can post the dwg I'll see if the issue occurs when I open it.