Corridor Generate additional lines

[muhammad.IsmailD4493]

Hi Everyone. 

By looking at image below you will sure clearly understand the issue with why corridor generated those offset lines while not been asked to draw.

Please share your knowledge. 

Thanks and regards

[arturopolanco]

Hi @muhammad.IsmailD4493 

Can you share printscreen about your Assembly and Subassemblies?

[muhammad.IsmailD4493]

Hi @arturopolanco 

Please refer below images for your review.

Regards

   

[nkiakas]

Hi @muhammad.IsmailD4493

@arturopolanco has right. Most of these problems come from the subassemblies.

Are the subassemblies of the snapshots custom with subassembly composer or used the build in subassemblies?

Could please also share your file?

Regards

[chriscowgill7373]

I cant tell what is going on from the screenshots, but, Daylight general, if you get over a specific elevation for the slope, it will go to the steep slope condition and will throw a guardrail shoulder into your section, causing the section to jump out whatever the width of that shoulder is.  In Imperial, it is a 2' shoulder at 2% that gets added.  We instruct our users to make sure it is set to 0' for the width if you are not planning on using it.