Corridor does not solve 90 degree angle

[Beka_Tchigladze]

Hello,

So I have an alignment and assembly done with the left and right side,

but corridor doenot solve 90degree angle, I tried to change frequency and angle also but it doesnot solve

[tcorey]

Often, designers will use a small curve in the corner to help civil 3d around the corner.

[Beka_Tchigladze]

Yes Me also but for some structures with the wide width at some point it creates a bowtie so this is very boring to do separate baseline for this issue,

so I noticed that when I appoint vertical target to the assembly for pile depth or the Kerb depth this cause the problem otherwise it works why? 

[cneelyPABBX]

Maybe you could skew the corridor where the PI is? Watch this video and see if it helps any.

https://www.youtube.com/watch?v=__bDC0OmObM

[Beka_Tchigladze]

no thank you this is not what I need 

[Beka_Tchigladze · Accepted solution]

So, I solved this problem that I use Transition editor, this was an assembly which could follow vertical target, so since I would assign vertical target it was not solved the corner anymore, So I used transition editor to neglect vertical target and have a various depth for my curb thank you anyway.