Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Please help! I'm trying to apply a raised median (see attachment) with a mark point at the opposite side. When I review my sections, the median does not appear. In the image, the assembly is above and produced corridor section below.
wrote in message news:5672637@discussion.autodesk.com...
Please help! I'm trying to apply a raised median (see attachment) with a
mark point at the opposite side. When I review my sections, the median does
not appear. In the image, the assembly is above and produced corridor
section below.
I think you need to offset your assembly( by default to the left) , and then link your median using the marked point on the right assembly( you can add a curb and gutter, and mark its top as the marked point). Hope it helps.
