Applying raised median

[Anonymous]

Please help! I'm trying to apply a raised median (see attachment) with a mark point at the opposite side. When I review my sections, the median does not appear. In the image, the assembly is above and produced corridor section below.

[Anonymous]

This blog post by Scott McEachron should help:

http://c3dpavingtheway.blogspot.com/2006/05/medians-and-marked-points.html

wrote in message news:5672637@discussion.autodesk.com...
Please help! I'm trying to apply a raised median (see attachment) with a
mark point at the opposite side. When I review my sections, the median does
not appear. In the image, the assembly is above and produced corridor
section below.

[Anonymous]

I think you need to offset your assembly( by default to the left) , and then link your median using the marked point on the right assembly( you can add a curb and gutter, and mark its top as the marked point). Hope it helps.

[wfberry]

I hope he hasn't been waiting 11 years for this.

Bill

[Anonymous]

And I hope no one runs to the same problem. Maybe the question deserved a reply after 11 yrs.
My bests,
Farhad