Weld Report Not Separating TapWelds
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I created a weld report which queries Buttweld, Socketweld, TapWeld, and FusionWeld. In that order.
The report itself is very simple, it just collects all welds and totals them.
You can see the query in the image below. When Buttweld is at the top, TapWelds get merged into Buttwelds of the same size. If TapWeld is at the top of the query list, then the Buttwelds turn into TapWelds of the same size.
Anyone know what the heck is going on here? All I am doing is pulling the Short Description but Report Creator keeps combining these two weld types if there are Buttwelds or TapWelds of the same size. Anyone know how I can split these up and just get a total for each type of weld?
Thank you.
