lapped joint connection

Anonymous · ‎10-14-2016

hello,

i'm at my wits end here.

so i'm in george fisher catalog/spec. i create a lapped flange ,see screen shot. but i cant connect anything to it! nothing! its so frustrating!

i know this is probably a connector issue but i cant figure it out.

please help

adrian

Anonymous · ‎10-15-2016

take screen shot from Connection Port Properties in spec editor and check matching pipe od.

rnoordam · ‎10-18-2016

Hello,

A lapped flange (port1=FL, port2=LAP) need a slip-on hub flange (port1=LAP, port2=BV) to connect.

Than a proper gasket (if lapped flange has RF face and a pressure class is 150 than the gasket also)..

And a Boldset (if lapped flange has RF face and a pressure class is 150 than the Boldset also)..

If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).

Rene Noordam

CADAC

Anonymous · ‎11-01-2016

HI Rene,

Sorry for my slow reply.

thanks for your help on this.

adrian

Imogollon1011 · ‎02-05-2021

Estimados yo tengo un problema similar con la junta lapped pero a las hora de crear un isométrico

no me sale las coordenadas ni mucho menos la continuación con la otra lineal que esta se conecta como puedo proceder

Community