Isogen start point for spool number direction

[PatrickByrne]

Is it possible to indicate the start point for a pipeline so that spool numbers follow the correct direction similar to the Isogenstartpoint command in CadWorx.

Our spool numbers follow flow direction.

[PatrickByrne]

Is it possible to indicate the start point for a pipeline so that spool numbers follow the correct direction similar to the Isogenstartpoint command in CadWorx.

Our spool numbers follow flow direction.

[VinodBalasubramanian]

I am afraid this isn't possible at the moment. However I can log this as a enhancement request with our development team and keep you posted.

I will also check whether there are anyother alternatives for this issue.

[VinodBalasubramanian]

I am afraid this isn't possible at the moment. However I can log this as a enhancement request with our development team and keep you posted.

I will also check whether there are anyother alternatives for this issue.

[Anonymous]

how about just keeping the ISO's in order as you go along a pipeline.

Currently, when dumping multipage ISO's, they 'jump' all over the place.

eg

sheet 1 - from sheet 3 to equip.

sheet 2 - from sheet 3 to sheet 5

sheet 3 - from sheet 1 to sheet 2

sheet 4 - from sheet 5 to header

sheet 5 - from sheet 2 to sheet 4

flow arrows go from header to equip!

[Anonymous]

how about just keeping the ISO's in order as you go along a pipeline.

Currently, when dumping multipage ISO's, they 'jump' all over the place.

eg

sheet 1 - from sheet 3 to equip.

sheet 2 - from sheet 3 to sheet 5

sheet 3 - from sheet 1 to sheet 2

sheet 4 - from sheet 5 to header

sheet 5 - from sheet 2 to sheet 4

flow arrows go from header to equip!

[dave.wolfe]

The start point is already on the request list.

[dave.wolfe]

The start point is already on the request list.

[PatrickByrne]

I asked this question back in 2012, I am currently using 2018, I know I can reverse the order in the advanced options but it would be good to have it saved in the model. I thought Start Point might solve the issue but alas no.

Anybody any other ideas

[PatrickByrne]

I asked this question back in 2012, I am currently using 2018, I know I can reverse the order in the advanced options but it would be good to have it saved in the model. I thought Start Point might solve the issue but alas no.

Anybody any other ideas