how to set serial number in report format?
Accepted solution
Dear @chetan.sakure ,
this would be a solution for you
-
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn
Back to the first question: where does your serial number come from?
The link I sent you is only for a count number of the lines.
Now for the second question, you want to change the nominal size from mm to imperial "?
-
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn
In what units is your Plant 3D project imperial or metric?
-
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn
If the project is in metric units then the report in the Report Creator should also be displayed in metric units or your report templates are reprogammed to imperial units. I don't have the information to help you with this.
-
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).
Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn
