Blind Flange - tap weld missing from Iso

MOLGRAND · ‎09-27-2018

Hi,

I have a slight irritation in that when adding a pipe run into the back of the blind flange, although it models well & there are no issues, but when I run the iso the tap weld doesn't show up on the iso. The only time it does appear iso is when you change the weld from a shop to field weld, then it does appear on the iso. When a SOL or WOL is added to the flange instead of the pipe then weld does appear on the iso correctly - so is the pipe connection weld a bug or can anyone advise a solution.

Regards

Gary Randall

h_eger · ‎09-28-2018

Dear @MOLGRAND,

unfortunately I can not repruduce your mistake.

-

If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).

Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn

MOLGRAND · ‎09-28-2018

Hi,

Thanks for coming back to me.

I am running P3D - 2018, what version did you generate the Iso on? I have reloaded 2018 again today from scratch to make sure I didn't have any software issues & I just created a new project metric-metric so its an out of the box set-up with no changes & used the final Iso template & I still get the same error result!

Regards

Gary

h_eger · ‎09-28-2018

Dear @MOLGRAND,

also in 2018 the action is successful

-

If my reply was helpful, please give a "Kudo" or click the "Accept as Solution" button below (or both).

Hartmut Eger
Senior Engineer
Anlagenplanung + Elektotechnik
XING | LinkedIn

Bernd.Gerstenberger · ‎10-05-2018

Dear Molgrand,

the reason therefore is in most cases configuration. Please, can you send us the following files:

Small sample model drawing
Zipped iso style folder
From <project folder>\Isometric the following files:
1. IsoSymbolStyles.dwg
2. IsoSkeyAcadBlockMap.xml
DefaultConnectorsConfig.xml from project folder

Best regards

Bernd G.

Senior Product Support Specialist