AUTOCAD PLANT 3D FLANGE CONNECTION

[ettiene.willemse]

Good day

I am having trouble with connection  a pipe to a valve. It pops up this error and i am not sure how to fix the problem.

Any suggestions?

[h_eger]

Dear @ettiene.willemse ,

there is no flange with Pressure Class 150 in the PipeSpec CS1500 you are using.

Can it be that you have a confusion of the Pipe Spec CS150 and CS1500?

[ettiene.willemse]

With the project we are busy with we had to make a CS1500 class because of the entire plant running on 150 bar.

[h_eger]

OK then in your Pipe Spec CS1500 is a wrong component with flange connection #150

[ettiene.willemse]

What should I add?

Because I don't understand the error

[schusterAPRO]

Hi @ettiene.willemse 

please check the connection ports of your valve...size, facing and pressure class and compare that to your flange from your spec CS1500. They must match to be connected.

[tech_kong_vip_s10 · Accepted solution]

The following three conditions must be met，not a single one can be omitted

1.Nominal diameter

2.Pressure rating

3.Sealing surface

I hope you can succeed