I am unable to utilize my CTB file when I plot. I have verified it is in the correct location: attached screenshot shows results of STYLESMANAGER command display. Are there settings in PAGESETUP or PLOT that pre-select the type of plotter table? Is there something else I should try?
Thanks.
Solved! Go to Solution.
Solved by chick.biker. Go to Solution.
Solved by h_s_walker. Go to Solution.
Can you show us a screenshot of the PLOT command pop-up where you would be using the CTB file?
It might give a clue as to why perhaps, like your DWG file is set to use STB instead (a DWG file never uses both CTB and STB at the same time).
EDIT: seems you had the same issue a few years back when you also upgraded https://forums.autodesk.com/t5/autocad-lt-forum/missing-ctb-file/m-p/9265212#M180009
HTH
is your drawing using STB files instead? If so at the command line type CONVERTPSTYLES
Howard Walker
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
This solved it. I started with a blank file pointing to the wrong plot table. Thanks.
Can't find what you're looking for? Ask the community or share your knowledge.