Thanks for mentioning the part I forgot to speak of John.
I was fairly sure it was in the KB article though.
(time passes during a check)
Underneath step 5, is where that is mentioned.
phew! 😉
--
Don Reichle
"The only thing worse than training your staff, and having them leave is -
not training your staff, and having them stay." 😮
A reminder taken from Graphics Solution Providers' Calendar page
--------------------------------------------------------------------
!! Please discuss whatever we tell you with your SysMgr !!
!! They appreciate staying in the loop 🙂 !!
CivilSeries-2K4
Intel Xeon 3.2GHz 2GB RAM
XPPro 32bit SP2
Nvidia Quadro NVS 285 256MB
"The only Constant is Change".
"John Mayo" wrote in message
news:5461418@discussion.autodesk.com...
On nice thing about laytrans is you can save the layer translations to use
again. That's about as close as you will get to an EASY button with this.
John Mayo
Project Engineer
Conklin Associates
Ramsey, NJ
Civil 3D 2007, LDT 2007, Raster Design 2007
P-IV at 3.5 GHz
2 GB Ram
Nvidea Quadro FX w/ 128 MB Ram
"Don Reichle" wrote in message
news:5461414@discussion.autodesk.com...
Obviously it (LayTrans) wasn't previously part of your repertoire Joe. 😉
--
Don Reichle
"The only thing worse than training your staff, and having them leave is -
not training your staff, and having them stay." 😮
A reminder taken from Graphics Solution Providers' Calendar page
--------------------------------------------------------------------
!! Please discuss whatever we tell you with your SysMgr !!
!! They appreciate staying in the loop 🙂 !!
CivilSeries-2K4
Intel Xeon 3.2GHz 2GB RAM
XPPro 32bit SP2
Nvidia Quadro NVS 285 256MB
"The only Constant is Change".
"Don Reichle" wrote in message
news:5461390@discussion.autodesk.com...
Express Tools Layer Translator (LAYTRANS at the command line) would make you
smile - I think. 😉
Here's a Tech Support article from the Desker's Knowledge Base (in my
tinyurl) for your enlightenment j_seph. Mainly due to not being able to find
Help in the Express Tools. The index in ET Help had it listed, but alas
there was a notice re. "cannot display the webpage" on my attempt to click
it;
http://tinyurl.com/35675m
I've used it with much gratitude in my recent past. It takes a little while
to setup for each firm you get dwg files from, but from then on - it's
gravy. And I tried it out just now, and it worked OK with LDT 2K4.
HTH
--
Don Reichle
"The only thing worse than training your staff, and having them leave is -
not training your staff, and having them stay." 😮
A reminder taken from Graphics Solution Providers' Calendar page
--------------------------------------------------------------------
!! Please discuss whatever we tell you with your SysMgr !!
!! They appreciate staying in the loop 🙂 !!
CivilSeries-2K4
Intel Xeon 3.2GHz 2GB RAM
XPPro 32bit SP2
Nvidia Quadro NVS 285 256MB
"The only Constant is Change".
wrote in message news:5461341@discussion.autodesk.com...
We get cad files from another company which of course use their own layer
standards. I am trying to find a way that I can convert their
layers,colors,linetypes to our standards w/o having to do each one
individually.
Thanks in Advance
