Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

View defaults to 0,0 when leaving block editor.

Anonymous

View defaults to 0,0 when leaving block editor.

Anonymous
Not applicable

Hard to search for this so decided to try and post. 

 

I go into block editor (AutoCAD 2018) and do what I need to do and then click the close block editor and save the block. When it takes me back to model space, the view is defaulting to 0,0 instead of where I was looking before going into the block editor. I have no clue why it does this or what to change to stop it from doing this. Any help would be great.

0 Likes
Reply
Accepted solutions (1)
1,506 Views
2 Replies
Replies (2)

C.Reid.Oran
Contributor
Contributor
Accepted solution

There are possibly a few reasons this happen, but I know that it happens in my drawings when I have 'ucsfollow' set to '1', if your not using this command, set it to '0' and it will behave for you

Anonymous
Not applicable

Thank you for the quick response.

0 Likes