Updating Existing Dimensions After Scaling

[Anonymous]

I've drawn a 2' square. I've pulled dimensions showing that the height and width are 2'. I selected the part and dimensions and scaled them up 2x. My dimensions are showing the part is now 4' tall and 4' wide. I adjusted the dimlfac from 1 to 0.5. If I pull new dimensions on the part they will show it to be 2' tall and 2' wide. How do I apply the dimlfac change to existing dimensions? Is there a command that does this? I appreciate the help.

[Patchy]

Go to dimstyle and change it, it should update all existing that use the style.

[S.Faris · Accepted solution]

To change the DIMLFAC of existing dimensions, you need to select the dimensions and the in the properties panel, under Primary Units adjust the Dimension scale Linear

[s.borello]

You can fix your issue if you follow the advice that's been previously posted.  My question is why are you scaling and not drawing 1:1 and using annotative dims? 

[pendean]

Why are you scaling the object, then "fudging" the dimensions to compensate?

[scot-65]

If you have manually set DIMLFAC (at the command prompt), then
command -DIMSTYLE "Apply" and select the existing dimensions.
Please note the hyphen "-" in front.

To make the dimension style permanent with this adjusted DIMLFAC,
command "DIM" "Save" "TheCurrentDimensionStyle" "Yes" "eXit"

No dialog required.

???

[Anonymous]

I don't want to change all of the dimensions on the DWG. Think of this as a detailed view of a small aspect of the larger part. It's been many years since I used AutoCAD. I "learned" how to draft on AutoCAD 2010. I am now using AutoCAD 2019. I could've sworn I remembered there being a short cut command to update dimensions after changing the DIMLFAC to correspond with the scaled up view, but I could be mistaken. I do know that I did not have to change the DIMSTYLE when I did this. I appreciate the help.

[Anonymous]

I "learned" how to draft on AutoCAD 2010. I am now using AutoCAD 2019. I could've sworn I remembered there being a short cut command to update dimensions after changing the DIMLFAC to correspond with the scaled up view, but I could be mistaken. I appreciate the help. Thanks.

[Anonymous]

Thanks for the response. I do start drawing at a 1:1, but sometimes I need to zoom in on a specific part. Scaling up a selection of the part allows me to provide better details. I'll have to look into annotative dims as I am not sure I've used them before. Thanks for the help.

[Anonymous]

A larger view will allow for more clarity when detailing/dimensioning.

[Anonymous]

I don't want to change the DIMSTYLE at all. Not every dimension will require updating as the entire part isn't being enlarged. I appreciate the help.

[pendean]

So we do all of that in a viewport in PAPERSPACE: that way you always draw at 1:, you never fudge a dimension, you never fudge a drawing either.

I take it you never transitioned to learn how to use Layouts and viewports? We issue sheets all day long with 3-4 different scales on one sheet in a layout without EVER having to fudge anything in modelspace.

Now would be a good time to learn if you are up to it, it will increase your productivity and lessen mistakes in modelspace.