Tool Palette Flyout

[stephenappel]

Not sure why but my tool palettes which are set to Auto-hide are now flying out taking up about 1/3 of my screen. Any help would be appreciated!

Thank you!

[pendean · Accepted solution]

@stephenappel May I ask why the option to resized them back down is not an option? You know, hover your mouse at the end until it changes to a side-to-side arrow, then drag back down to the width you prefer

Or is someting else going on?

[Valentin-WSP]

@stephenappel ,

See other suggestions on this link:

• Properties window not showing in AutoCAD

[stephenappel]

Well once again you point out the obvious! When I hover over the right edge
of the flyout there is no side to side arrow which I looked for before.
However I discovered that even without the side to side arrow I can place
the cursor on the edge and pull it back in! Thanks again for your help!