Student

[Narrotam.Benny]

I'm a student stuck on this auxiliary view. But the view isn't the problem, i can't figure out to draw the figure. 

[jrreid · Accepted solution]

The top piece 2 x 1 needs to have a 0.41 straight down from there.

Then rotate from center 30 degrees

Then Trim it up but there cannot be any short lines from point to point.

You have to do some clean up then make it one connected PLINE Closed before you can extend it for 3D.

Hope this helps.

JRR.

[Narrotam.Benny]

Thank you very much.

[jrreid]

Your welcome! That was fun to do! Wish you well in your CAD adventure!
JRR.