Publishing problems

[2204008HBM8M]

Centerline shows as it should in the model tab but in the layout tab, it shows as a continuous line and plots and publishes as a continuous line

[imadHabash]

Hi,

Try to check PSLTSCALE (System Variable)

[2204008HBM8M]

It is 1.

[pendean]

---

@2204008HBM8M wrote:
It is 1.

---

change it then REGENALL would be the next step to try after only just checking.

Also, what are your settings for LTSCALE and MSLTSCALE too please?

[imadHabash]

can we have a CAD dwg sample please for testing?

[imadHabash]

can we have a CAD dwg sample please for testing?

[2204008HBM8M]

I have attached the file. You can check it now.

[2204008HBM8M]

Both of them are 1 and REGENALL did not solve the problem.

[wispoxy]

/Go to your layout
/Lock viewport and go inside of it
/Use command PSLTSCALE
/Use REGEN while in viewport
/Exit viewport and REGEN again while on your layout
/Switch tabs and return to the tab

.//If modelspace is 1:1 and layout viewport is 1:1 it should work.

.//If modelspace is 1:1 and layout viewport is 1'=1/8"-0' keep in mind of your line pattern scales. You need to enlarge or make the linescale 0.0015 or 48 or 96. When I say "enlarge" I'm specifically talking about the linepattern not the object itself "Linetype Scale" in properties of the line. You may need to play around with show annotations too.

[2204008HBM8M]

Did not work.

[CodeDing · Accepted solution]

@2204008HBM8M ,

When you're in Model Space, See how your scale is set to 1:1?

Then, when you go to your Paper Space and enter your Viewport, See how your scale is set to something else?

...That is your problem. To fix it, do the following:

1) Set the scale inside your viewport to: 1/4" = 1'-0" (then, lock your viewport)

2) Then, go back to Model Space and set your scale to the same thing (1/4" = 1'-0")

3) Then run the REGEN command

4) Then, adjust your LineType Scale(s) to their appropriate sizes. I changed your centerlines to 0.2.

Best,

~DD

[2204008HBM8M]

Perfectly solved. Thank you very much.

[wispoxy]

I got a feeling something is being represented to us incorrectly. You said "centerline", that term means a specific pattern + line + purpose. Are you not talking about a pattern, line, and purpose? Please describe "Centerline", you're not using the word "the" before saying "Centerline" so I assume we're thinking of it differently.

[wispoxy]

He showed you exactly by image what I typed out, and you said mine didn't resolve the problem. 🤣

[2204008HBM8M]

I was accessing this page using my laptop then and it didn't show the lines beneath the "return to the tab" line. Now I am checking it from my phone and the rest of the instructions are showing here. 

[2204008HBM8M]

Yes, I should have put that "the" there. Sorry for my mistake. English is not my native language, so I missed it.

[wispoxy]

I wasn't picking on your language because it works both ways. When you said what I listed didn't work I re-read your original post and noticed it without the word "the" at the start, so I started thinking you were talking about another object or block named "Centerline" and not the actual centerline pattern or feature. All good!