Hello,
I have a profile section that shows elevations from above and below ground level. Here is an example if ground level was 50.0'.
53.0'
52.0'
51.0'
50.0'
49.0'
48.0'
47.0'
I am trying to create a block, or some sort of automated way of doing this. For example, if this were a spread sheet you could fill in 50.0' and then excel would understand to add or subtract 1 unit depending on which way the range was going.
I tried TCount but it doesn't really customize...it can count up or down but doesn't properly format the text. I can't have 50. it needs to be 50.0'.
I'm sure there is a feature for this in AutoCAD...it seems simple enough I'm just not sure on which way to go about this. I want the user to enter the ground elevation and all other numbers above and below that point to auto-update by 1 unit.
Thank you!
Solved! Go to Solution.
Solved by pendean. Go to Solution.
Solved by Patchy. Go to Solution.
Can't find what you're looking for? Ask the community or share your knowledge.