Help me with the drawing - AutoCAD 2022

[gukuvegetasherif23]

Can anyone tell how can i drew that i know i must use polygon but didn't know what to do after

@gukuvegetasherif23 Your post title was modified to add the product name and version and to increase findability - CGBenner

[leeminardi]

Post an AutoCAD file of what you are able to do for both constructions.

[imadHabash]

Hi,

For the left image ...

You can draw it by POLYGON command ... all what you have to do is to change the number of side for every polygon shape starting from 3 till 10 then enter E for Edge option and pick two corners at 10.00.

Command: POLYGON
Enter number of sides <>: 3
Specify center of polygon or [Edge]: E
Specify first endpoint of edge: Specify second endpoint of edge:

For the Right image ...

I'll give you a hint .. you have 6 arrayed objects. Just draw one of the six then use array command ... Let us see your attempts and through them we can help you more.

[gukuvegetasherif23]

I used offest  2 between each so i can make same shape but iam kinda lost and how i cam incorporate array to this

[imadHabash]

Good start ...
The center of circle in my massage #3 is the center of Array(Polar) procedure. You have to trim the object first then use array command from the point that i describe it for you. Keep going your try and get back for any question. >> Click << 

[gukuvegetasherif23]

How can i use the rows and columns so i can replacte the shape and where fo i trim 

Iam not that experienced in array srry

[imadHabash]

You have to use Array command with Polar option.. Click on below image

[imadHabash · Accepted solution]

I have attached an illustration image in my previous massage #7 for you.

[gukuvegetasherif23]

what about this i did the circle and as u toldi did the polar array with fillit on the circle but i cant seem to know what do in the middle shape and what does angle 45 mean

[imadHabash]

Good start ...
Just draw the first vertical line ... then fillet it with the circle (0.40) then array it (Num=8) then Mirror all the 8 to get the final needed result.

[gukuvegetasherif23]

I did like in the vid and it showed up like this

[imadHabash]

Make sure that distance=0.60 from the vertical axis is achieved. 

[gukuvegetasherif23]

My bad i writed the distance wrong 

[gukuvegetasherif23]

With this i tried everything i tried going from quadrant 2.5 left and line up and fillet didnt work