Hi I need to draw parallel lines to create for example a staircase. By using the parallel or offset command, I can make the parallel lines but the angle of rise of the lines cannot be altered. Is there a way where this can be changed?
\Pls give solution if possible.
Thanks
Gazaal
Hi @gazaal_c
Try using "COPY" command with array🙂
Hi,
I think that you're asking about drawing an isometric stair . click on below image and see how with ISODRAFT command you can do it. you can draw 2D isometric representations of 3D models .you can while drawing the stairs switch your direction by Ctrl+E . also you can draw a real 3d stair model by using 3d commands.
Imad Habash
click on below image to see how with EXTRUDE 3d command you can do a 3d solid stair . prepare your 3d polyline stair elevation in a proper angle then just extrude it .
Imad Habash
@imadHabash wrote:
.... I think that you're asking about drawing an isometric stair . ....
I don't think so. See the caption under the image in Message 1. @Anonymous, can you clarify?
Can't find what you're looking for? Ask the community or share your knowledge.