BLOCK ATTRIBUTES COMBINATION

[Anonymous]

Hi, experts

I am creaing a block with 3 attributes, I just want the 3rd attributes get the values of previous 2 attributes, I insert the fields into the 3rd attributes value then concatinate the previous 2 attributes values, after inserted those blocks, I just snychronize the blocks but the 3rd attributes cannot updated;

if there any advice regarding this issue?

thanks a lot in advance;

[Alfred.NESWADBA]

Hi,

while you are in block-editor and use command _ATTDEF to define your attribute make sure the checkbox "Display value for block reference" is activated!

Look to the video which shows the complete workflow, I also attached the modified dwg-file.

HTH, - alfred -

[Anonymous]

Thank you very much, I will try it out a little bit later.

---

@Alfred.NESWADBA wrote:

Hi,

while you are in block-editor and use command _ATTDEF to define your attribute make sure the checkbox "Display value for block reference" is activated!

Look to the video which shows the complete workflow, I also attached the modified dwg-file.

HTH, - alfred -

---