Community
AutoCAD Forum
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

AutoCAD - Dynamic Input not working

2 REPLIES 2
Reply
Message 1 of 3
liena6WEUH
405 Views, 2 Replies

AutoCAD - Dynamic Input not working

Hi!

Dynamic Input mode suddenly is not working. When setting DYNMODE to 3, it is impossible to type anything, command line is just "blinking" with every letter while typing.
When setting DYNMODE to 2, it's working - commands are typed at the command line wherever it is situated (in my case - at the bottom of the screen). 

But as I have been working with typing commands next to cursor, it is so annoying to type commands at command line. 
I reset Autocad to defaults and it's still not working.


Does anyone have a solution for this?! Thanks!

Liena

 

[ The subject line of this post has been edited for clarity by @handjonathan Original: Dynamic Input not working ]

Labels (2)
2 REPLIES 2
Message 2 of 3
pendean
in reply to: liena6WEUH

Was there an update on your PC overnight or since it all last worked?
Your OS is...?
Your ABOUT command lists what as your AutoCAD version?
GRAPHICSCONFIG command pop-up lists what as all of your options and selections?

Did you restart your PC before opting for the drastic reset of AutoCAD?
Message 3 of 3
Edwin.Rense
in reply to: liena6WEUH

Set DYNPROMPT to 1 to show the command next to your pointer.
Next to DYNMODE=3

 

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!

Kind regards,

Edwin Rense
Cadac Group AEC BV
Supporting Consultant AEC
Cadac Group .

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

AutoCAD Inside the Factory


Autodesk Design & Make Report