Community
AutoCAD Forum
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

autocad 2014

3 REPLIES 3
Back to AutoCAD Category
Back to Topic Listing
Reply
Message 1 of 4
Anonymous
312 Views, 3 Replies
‎03-31-2016 10:54 PM

autocad 2014

Anonymous
Not applicable
‎03-31-2016 10:54 PM

when i want to draw an un straight line on autocad it became dash line and sometimes unvisible ... and also the circle or a curve ..... please help

 

autodesk problem.dwg
0 Likes
‎03-31-2016 10:54 PM

autocad 2014

when i want to draw an un straight line on autocad it became dash line and sometimes unvisible ... and also the circle or a curve ..... please help

 

autodesk problem.dwg
Report
0 Likes
Reply
3 REPLIES 3
Message 2 of 4
Anonymous
in reply to: Anonymous
‎03-31-2016 10:59 PM

Anonymous
Not applicable
‎03-31-2016 10:59 PM
seems to work fine for me. double check Z levels perhaps? maybe try using "flatten" command
0 Likes
‎03-31-2016 10:59 PM

seems to work fine for me. double check Z levels perhaps? maybe try using "flatten" command
Report
0 Likes
Reply
Message 3 of 4
ennujozlagam
Mentor
in reply to: Anonymous
‎03-31-2016 11:06 PM

ennujozlagam
Mentor
Mentor
‎03-31-2016 11:06 PM

hi, nothing wrong with your drawing, when want to draw staight line just press F8. set your line type "bylayer". go to your layer, set your linetype tp "continuous. in command prompt type viewres > set value to 20000. hope it helps. thanks

 

line.JPG

 

line2.jpg





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
‎03-31-2016 11:06 PM

hi, nothing wrong with your drawing, when want to draw staight line just press F8. set your line type "bylayer". go to your layer, set your linetype tp "continuous. in command prompt type viewres > set value to 20000. hope it helps. thanks

 

line.JPG

 

line2.jpg





Remember : without the difficult times in your LIFE, you wouldn't be who you are today. Be grateful for the good and the bad. ANGER doesn't solve anything. It builds nothing, but it can destroy everything...
Please mark this response as "Accept as Solution" if it answers your question. Kudos gladly accepted.
Report
Reply
Message 4 of 4
pendean
Community Legend
in reply to: Anonymous
‎04-01-2016 05:36 AM

pendean
Community Legend
Community Legend
‎04-01-2016 05:36 AM
I can't reproduce the issue in your file either.
0 Likes
‎04-01-2016 05:36 AM

I can't reproduce the issue in your file either.
Report
0 Likes
Reply
Reply

Forums Links

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

AutoCAD Inside the Factory


Autodesk Design & Make Report

Report a website issue