Add command DELCONSTRAINT to the ribbon and tool palette

[Mike_Y2]

Hi,

I can add AutoCAD commands to the ribbon and/or a tool palette. But some commands seam to be missing when you search for them. I am trying to add "DelConstraint" but when I start searching for it, there aren't any commands shown in the list - see pic below. Any ideas what I am doing wrong?

Note the command is currently in my ribbon but I want to add it to a tool palette

[cadffm]

There is no "Command" in commandlist with name Delc*

Try Del*

[Mike_Y2]

@cadffm 

I am aware "Delc" isn't a command but as you start to type the commands in the list are automatically filter down - see example pic below when I search for "adj" and you will see the 6 results

A wildcard doesn't seam to work when searching and unless I am mistaken it isn't required. I suspect "DELCONSTRAINT" has an alternative name. The command "Burst" command is found by searching for "Explode attributes to text"

[Mike_Y2 · Accepted solution]

Found it...

You need to use the full name instead of the abbreviated name...

[Valentin_CAD]

@Mike_Y2 ,

---

@Mike_Y2 wrote:

... I am trying to add "DelConstraint" ... to a tool palette

---

If not there then:

Create a New Command in your CUI, then write a Macro and add to a Toolbar / Tool Palettes - see Link.

• CAD Command and Control: Macros and Tool Palettes

"click and drag your command from the command list to your new palette. This will allow you to run your command from the tool palette. "

[pendean]

---

@Mike_Y2 wrote:

...You need to use the full name instead of the abbreviated name...

---

That's almost always the case in the CUI pop-up.

[ВeekeeCZ]

If you KNOW where it is in Ribbon, then follow the path and locate the command. When you do, click on the command's icon...

BTW keyword "constr"... will find it.