3d Path Array

[Anonymous]

How to 3d path array an object with a specific slope. Any idea or Lisp?

[imadHabash]

Hi,

usually i do this by draw this object at slope angle then i use 3DARRAY (Rectangular) command. 

• draw the object that you want to array.
• make your UCSICON at the same slope level by using UCS command the select Face option. 
• start 3DARRAY command and take care about positive and negative values since Positive values generate the array along the positive X, Y, and Z axes. Negative values generate the array along the negative X, Y, and Z axes.
• your success depend on the values that you enter.

Good Luck..

[Anonymous]

This is Rectangular array. I want path array,

I have curves and arcs. I would like to array an object on them. 

[imadHabash]

Hi,

in your first Post >> How to 3d path array an object with a specific slope <<  and now >> I have curves and arcs << !!!

>> This is Rectangular array. I want path array, <<  to get that try to use ARRAYPATH command.

regards,

[john.vellek]

Hi @Anonymous,

Can you give me more details on what you are trying to create? I suspect your issue is in drawing the path and not the array part of this.

Without any more information, I suggest using construction lines/points to assist  you in laying out your 3D curved path.

Please select the Accept as Solution button if my post solves your issue or answers your question.

[john.vellek]

Hi @Anonymous,

I am checking back to see if my post or others helped you with your problem.
Please add a post with how you decide to proceed and your results so other Community members may benefit.

Please select the Accept as Solution button if a post or posts fully solved your issue or answered your question.

[Anonymous]

Hi Mr John.Vellek

i am very Sorry For  Late Reply. 

Actually I was trying to Calculate the Gradient and Camber Levels on Road.

So i was thinking that if i can path array, my points to selected Center line of road, with specific Slope, then i can get levels on 3 meters interval.

so the problem was solved in Civil 3d program

please check this post. is it possible in AutoCAD?

http://forums.autodesk.com/t5/autocad-civil-3d-forum/need-levels-on-gradient-amp-camber-on-road-3m-i...

[john.vellek]

Hi @Anonymous,

This is a tricky one. While I think you can probably do this in AutoCAD it would be rather tedious. Can you attach a simple drawing that illustrates your road? If so, I will take a look for you. I suspect it might be better thought  to move this thread to the Customization forum to see if someone has a LISP routine that can do this.