Unable to launch new installation of AuroCad LT 2016 for Mac

[rolandoxgutierrez]

I recently re-installed the Mac version of AutoCad LT 206 because the existing installation was unable to launch the application. It gets stuck in the initial screen. When at toggle Force Quick it shows the application in red with the message "Not Responding"

Please advise on possible motives for the above. 

I am current in my monthly rental fee and my Mac Version is Yosemite 10.10.5

Thank you for your assistance

Rolando

[maxim_k · Accepted solution]

Welcome to Autodesk Forums!

Hi Ronaldo,

You may have to try clean uninstall of AutoCAD :

https://knowledge.autodesk.com/support/autocad-for-mac/troubleshooting/caas/sfdcarticles/sfdcarticle...

Than try to install it again.

Maxim

[Emmsleys · Accepted solution]

I would recommend the following: 

• Clean uninstall as suggested 
• Download your product from the virtual agent 
• Apply all service packs 

Please post back in the thread and let me know if you are able to try the above suggestions. 

Thanks. 

[rolandoxgutierrez]

Thank you for your quick reply, your suggestions helped.

[rolandoxgutierrez]

Thank you so much, it worked.

[rolandoxgutierrez]

Thank you very much, it worked!!

[Anonymous]

I have OS El Captain V 10.11.1 

I have downloaded the student version of Maya twice. After this: 

It says "done" and nothing happens!! I don't know where it goes but it's not progressing. I am about to throw it out of the window. I also have HW due tomorrow on Maya. So annoying. 

[Anonymous]

I can't find a number to call Autocad support. 😠

[Anonymous]

I have downloaded from virtual agent. The same thing occurred. I don't have any walls up. I have enough space. I just don't understand what is happening. 

[maxim_k]

Welcome to Autodesk Forums!

Hi,

This is AutoCAD for Mac Forum, you can ask about Maya here:

http://forums.autodesk.com/t5/maya-forum/bd-p/area-b201

Installation forum is here:

http://forums.autodesk.com/t5/installation-licensing/bd-p/24

Maxim