Area in the Properties Inspector

[Anonymous]

I have a drawing that has lots of hatches with different shapes. If I select 2 hatches or more, on my Properties Inspector the area will show multiple values (Area: Multiple Value). Before, it used to add the total selected area. How can I activate this again? I don't want to calculate it by myself of use Area>add Area>Object. 

The previous one was much faster. 

[Anonymous]

I have a drawing that has lots of hatches with different shapes. If I select 2 hatches or more, on my Properties Inspector the area will show multiple values (Area: Multiple Value). Before, it used to add the total selected area. How can I activate this again? I don't want to calculate it by myself of use Area>add Area>Object. 

The previous one was much faster. 

[maxim_k · Accepted solution]

Welcome to Autodesk Forums!

Hi,

In the Properties palette at the top of the properties list change to "All"  instead of "Essentials":

You will see Comulative area at the bottom.

Maxim

[maxim_k · Accepted solution]

Welcome to Autodesk Forums!

Hi,

In the Properties palette at the top of the properties list change to "All"  instead of "Essentials":

You will see Comulative area at the bottom.

Maxim

[Anonymous]

Thank you so much.

[Anonymous]

Thank you so much.