cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Arcs and wire numbers

Arcs and wire numbers

It would be nice if arcs could be assigned a wire number when they are on a defined wire layer.  For example, to make the schematic more aesthetically pleasing, I like to fillet a wire at a 90 degree connection point.  However, the resulting arc cannot be assigned a wire number and the wire is no longer a continuous length of wire, but two different wires with different wire numbers.  It should remain one continuous wire.

2 Comments
testsubject
Advisor

Maybe not the answer you are looking for, but you could create symbols to do this (similar to the angled T markers)

clarkr8SA7L
Explorer

Yes, symbols could work, but many would be required to fit each situation (i.e. different radii, different circular quadrant locations, different arc segment lengths, etc.).  It would be much easier if any polyline, arc, etc., would be converted to a wire once placed on a wire layer (just like a line segment).

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Autodesk Design & Make Report