Dash in Device Name does not show in BOM

[Anonymous]

Hello,

Our default naming convention for our prints requires a "-" in front of the device name.

The format is -%F%S%N, so a limit switch would be named -LS4502, for example. It shows up fine in the schematics, but when I run a BOM report, the dash disappears. 

I have tested it, and any other custom symbol shows up when I run a BOM report, but not the dash.

Am I missing something?

Thanks!

[ramesh.kambang · Accepted solution]

This can be achieved, see marked in RED below:

[Anonymous]

That works! Thank you!