Hello,
Our default naming convention for our prints requires a "-" in front of the device name.
The format is -%F%S%N, so a limit switch would be named -LS4502, for example. It shows up fine in the schematics, but when I run a BOM report, the dash disappears.
I have tested it, and any other custom symbol shows up when I run a BOM report, but not the dash.
Am I missing something?
Thanks!
Solved! Go to Solution.
Solved by ramesh.kambang. Go to Solution.
This can be achieved, see marked in RED below:
Can't find what you're looking for? Ask the community or share your knowledge.