Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Submitted byAnonymouson02-28-201604:31 PM
Status:
Gathering Support
Pipe Network pipe inverts in & out
Just a minor suggestion. When adding levels to pipe properties could there be an (IN) or (OUT) added to the Start Invert Elevation and End Invert Elevation. It can sometimes get a bit confusing when the pipes have been drawn either upslope of downslope.
