Message 1 of 3
Surface Fillet Continuity Update Problem
Not applicable
02-28-2018
04:24 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Look into the 2018.0 file i attached. It is not posible to me to force the surface fillet tool achieve at least positional continuity.
I can change all the settings and the surfaces are updatet accordingly. But the position is not achieved. Therefore other fillets, crossing this surfaces, will fail. Undoing the fillet and building it new gives no problems.
For some reasons it refuses to adjust the grading of the fillet surface.
Sure in this case it would be no problem to build the surface new. But actually it is embedded in a model with a lot of other geometry crossing this surfaces and all are combined using the fillet tool. So deleting this fillet results in lots of work.