Due to scheduled maintenance, the Autodesk Community will be inaccessible from 10:00PM PDT on Oct 16th for approximately 1 hour. We appreciate your patience during this time.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hello, after giving the command to bend the plates in Advance Steel, it is not possible to perform resizing (enlarging or reducing) the plate. Adding a command to cancel the bending would greatly improve functionality. Currently, when a mistake occurs while drawing a silo funnel, it causes time loss as the bent parts need to be redrawn repeatedly. It would be very beneficial if you could add this feature to the software.
you don't have to redraw the entire bent sheet, simply right-click on the bend, select delete bend (special function - don't delete it classically), edit the sheets and connect them again to the bent configuration.
Since 03/2023, Advance Steel is in Maintenance mode, no further development from Autodesk.
