Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Please make depth control available in automatic cut views.
We need this very often when sections are cut at rolled / cambered beams, and currently we have to re-do the section views manually in order to show them properly.
Agreed, this should be easily manipulated in the drawing out put by an additional node attached the sections that allow dynamic adjustments to the sections.
We abandoned this program over 4 years ago. It is the red-headed stepchild of Autodesk and is a good (at best) tool for a very niche drafting market. You would be better off learning literally anything else.
