Solved: Re: problem with connection

eyal.ch · ‎12-10-2022

hi all,

I can't create the connection of gusset plate to column and base plate. like in the picture below.

I picked the command (marked in yellow) picked the column and the plate and the C purlin,

and I get this message:

what is it? and what is the problem?

Thank you

steve.bekkers · ‎12-13-2022

its a bit hard to see what is going on?

Sebastian_Eiche · ‎12-14-2022

a sample model.dwg would be good

Sebastian Eiche
Application Engineer @Mensch und Maschine acadGraph

If this information was helpful, please use the Accept as Solution function, this make it easier for other users

mick-CNF · ‎12-14-2022

Hi @eyal.ch

As @Sebastian_Eiche can you attached the model to see what is happening?

It is working OK for me unless yours is different?

If this information solves your problem please accept as a solution.

AleckGiles · ‎12-19-2022

Hi,

If the Magenta beam is the "Diagonal Beam" selected for the joint it won't work because it is not diagonal it is perpendicular to the column. It likely results in a divide by zero or something in the code.

Aleck Giles, Structures Consultant, Graitec
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

steve.bekkers · ‎12-19-2022

is this what you are trying to do?

eyal.ch · ‎12-19-2022

Thank you all,

@AleckGiles - thats right, it solves the problem.

problem with connection

problem with connection

Forums Links

Post to forums