Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
i have minor problems when editing and cutting concrete blocks. In the screencast shown below, the cuts jump around if i change the outer dimensions of a concrete block. I lose a lot of time putting them back in place. Is there a way to create cuts with a polyline which dont change their place. It is possible with plates but is it possible with concerete blocks or columns?