Quadrify question

[Anonymous]

Anyone know the script command for Quadrify selection? Not quadrify or quadrify mesh modifier. They seem to produce different results.

Quadrify selectin give me lower poly count then Quadrify mesh does event with the quad size % cranked way up.

thanks

[raiden_xavier]

Hello!

I noticed this post never got any replies.
Is this still an issue?

If it was resolved:
Please post what worked and choose 'Accept as solution'

If it wasn't resolved:
Perhaps I can help?

Having more solved posts makes a stronger community and helps future visitors.
Thanks!

[Anonymous · Accepted solution]

actually it did not get resolved but this is what i'm using

I download Quadrify from scripspot and made a tool bar

macros.run "Modifier Stack" "Convert_to_Poly"
macros.run "PolyTools" "Quadrify"

[raiden_xavier]

Hi @Anonymous,

Sorry to hear it didn't get resolved, but thanks for updating the thread and helping anyone else that may run into this.

[Anonymous]

No problem at all. Its kind of tricky figuring out when your not getting a resolution and close the thread. One tends to leave it open in hopes to get a resolution after time goes on one (in this case I) forget lol