When LISP executes AUTOCAD Text Window Pops Up

[Anonymous]

My routine appears to work properly in my environment, but everytime that I run the LISP the command history text window pops up.

Bytheway, I am fairly new to LISP.

See attached txt file.

Thanks!

[scot-65 · Accepted solution]

A quick look here I did not see errors.
There are two routines in this file - Which one causes the (textscr)?
Substitute "-layer" with ".layer", etc.
Try adding (graphscr) before the (princ).

???

And Welcome to these Forums!

[Anonymous]

Thanks for the quick reply!

Well, if I run the routine "cpurge" by itself it causes the command window to pop-up.

[Anonymous]

After incorporating both of your suggestions my LISP runs fine

1. changing (-layer) to (.layer) or (-purge) to (.purge)

2. adding (graphscr) before (princ)

Thank you!